Why is my Smeg Washer not spinning?
If your Smeg washer isn't spinning, it may be due to the anti-imbalance safety device being tripped because the laundry is not evenly distributed in the drum. If the laundry is still wet at the end of the cycle, rearrange it in the drum by hand and repeat the spin programme only.
What to do if my Smeg Washer is not pumping out water?
If your Smeg washer isn't pumping out water, check that the drain hose is not kinked and the drain pump is not blocked.
Why is water not pumped out after last rinse in delicate fabrics and wool wash programmes in Smeg LBF127 Washer?
If the water is not pumped out after the last rinse in delicate fabrics and wool wash programmes on your Smeg washer, it is not a malfunction but a pause programmed into the washing programme to prevent creasing of fabrics. To pump out the water, proceed as described in the "Programme End" point.
How to fix a Smeg Washer that does not start?
If your Smeg washer isn't starting, make sure the plug is correctly inserted into the socket, the door is securely closed, and the “Start/Pause” button has been pressed.
Why is my Smeg LBF127 Washer not filling with water?
If your Smeg washer isn't filling with water, check that the plug is properly connected to the socket, the door is securely closed, the water tap is turned on, the water intake hose filters are not blocked, and the water intake hose is not trapped or kinked.
Why is my Smeg LBF127 Washer vibrating so much during spin cycle?
If your Smeg washer is vibrating strongly during spins, ensure the appliance is properly leveled, it's not too close to walls or kitchen units, and the internal unit on flexible mounts is locked in position.
How to reduce foam in my Smeg LBF127 Washer?
If there's too much foam in the tank and it's flowing out of the drawer of your Smeg washer, make sure the detergent used is recommended for automatic washing machines and not for hand washing, and that the quantity used is as stated in the manual and no more.
Why is laundry not properly spun in my Smeg LBF127 Washer?
If your laundry is not properly spun in your Smeg washer, it could be because large items are screwed up and not evenly distributed within the drum. Always wash a mix of large and small items.
Why are there traces of detergent on my laundry after washing in Smeg LBF127 Washer?
If you find traces of detergent on your laundry after washing in your Smeg washer, it may be because many phosphate-free detergents contain substances with low water solubility. Select the Rinse programme or brush the laundry.
Why is not all fabric conditioner used in my Smeg Washer?
If not all the fabric conditioner is used or there is too much water left in the compartment of your Smeg washer, check that the detergent drawer siphons are correctly fitted and not blocked.
To Next Page
General
