Smeg LBF127 - Additional Information for the User

EN
25
7. ADDITIONAL INFORMATION FOR THE USER
The following information is provided in accordance with the European Ecodesign regulation (EU) 2019/2023
The values indicated for programs other than Eco 40-60 are indicative only.
Washing machine
Cycle Rated
capacity
(kg)
Energy
consum-
ption
(kWh/
cycle) *
Water
consum-
ption
(l/cycle) (*)
Programme
duration
(h:min)*
Temperature
Max.
(°C)
5 min (*)
(***)
Spin
speed
(rpm) *
Residual
moisture
content
(%) *
Detergent
Eco 40-60** 7 1.02 49 2:50 46 1400
(1200)
(1000)
48
(55)
(61)
Washing
powder or
liquid deter-
gent for co-
lours, wi-
thout bleach
or optical
brighteners
For white
and light-
coloured
laundry, use
a
Standard
detergent
with white-
ners.
(from cold
wash up to
90°C).
Refer to the
programs
table
Eco 40-60** 3.5 0.70 43 02:40 36 1400
(1200)
(1000)
49
(56)
(62)
Eco 40-60** 2 0.50 39 02:30 32 1400
(1200)
(1000)
54
(60)
(65)
Cotton 20°C 7 0.24 62 01:51 20 1400
(1200)
(1000)
53
(57)
(63)
Cotton 40°C 7 0.38 62 01:51 40 1400
(1200)
(1000)
53
(57)
(63)
Cotton 40°C +
Pre-wash cy-
cle
7 1.02 78 02:18 40 1400
(1200)
(1000)
53
(57)
(63)
Cotton 60°C 7 1.11 62 01:51 55 1400
(1200)
(1000)
53
(57)
(63)
Easy care
40°C
3.5 0.62 50 01:43 40 1000 30 Detergent for
colours /
delicates wi-
thout optical
brighteners
Mixed load
40°C
3 0.40 36 00:50 40 1200 57 Standard
detergent
without whi-
teners
Wool 30°C 2 0.20 49 00:47 30 600 55 Detergent for
woollens
* The actual values may differ from those indicated due to the pressure, hardness and temperature of the inlet
water, the ambient temperature, the type, amount and soiling of laundry, the type of detergent, fluctuations in the
mains power supply and any additional functions that have been activated.
** Test programme compliant with European Ecodesign regulation (EU 2019/2023) and the European regulation
on energy labelling using cold water (15°C) (EU 2019/2014)
*** Maximum temperature reached for a minimum of 5 minutes inside the laundry being treated.
IMPORTANT NOTICE FOR TESTING INSTITUTES.
Models intended to be built into a cabinet must be tested in an approved test cabinet with the front panel mounted
in accordance with the manufacturer's installation instructions.