Smeg LBP3T94PIT - User Manual

Questions and Answers

J
Jessica HoodAug 17, 2025
How to fix a Smeg LBP3T94PIT that won't start?
- Z
  Zachary WeaverAug 17, 2025
  If your Smeg Washer doesn't start, there might be several reasons: * It might not be plugged in, so ensure it is properly connected to a power outlet. * The fuses could be faulty, requiring replacement. * There might be no mains power supply, so check your power source. * The Start/Pause button may not have been pressed; make sure to press it. * The programme dial might be in the ‘stop’ position; turn it to the desired programme. * The machine door might not be completely closed; ensure it is securely shut.
S
Sara BrownAug 20, 2025
Why is the spin cycle delayed in my Smeg LBP3T94PIT?
- R
  rwilliamsAug 20, 2025
  If the spin cycle in your Smeg Washer is delayed or doesn't occur, it may be because the Unbalanced load control system has been activated. This system will attempt to spread your laundry, and the spinning cycle will begin once the laundry is spread. For the next wash, load the drum evenly.
T
Tamara LindseyAug 23, 2025
How to improve washing results with Smeg LBP3T94PIT Washer when using hard water?
- L
  Larry BullockAug 23, 2025
  If you're experiencing unsatisfactory washing results with your Smeg Washer and you have hard water, try increasing the amount of detergent, following the manufacturer’s instructions. Also, ensure that your laundry is spread out in the drum.
T
Travis TaylorAug 26, 2025
What to do if my Smeg Washer is not intaking water?
- B
  Bruce SimonAug 26, 2025
  If your Smeg Washer isn't intaking water, check the following: * Ensure the water tap is turned on. * Inspect the water inlet hose for any twists and untwist it. * The water inlet hose might be clogged, so clean the filters. * The inlet filter itself could be clogged, so clean the inlet filters. * Also, make sure that the machine door is completely closed.
G
graywesleyAug 28, 2025
Why is my Smeg Washer vibrating so much?
- S
  Shelly ColeAug 28, 2025
  If your Smeg Washer vibrates, it could be due to a few reasons: * The feet may not be adjusted properly; make sure to adjust them. * Transit bolts fitted for transportation might not have been removed; remove them. * If you have a small load in the drum, this won't prevent operation of your machine. * The machine might be overloaded or the laundry is unevenly spread; avoid overloading and spread laundry evenly. * The machine could be resting on a hard surface; avoid setting up your washer on a hard surface.
P
Peggy OlsonAug 31, 2025
What to do if my Smeg LBP3T94PIT does not discharge water?
- D
  Dr. Brittany DavisAug 31, 2025
  If your Smeg Washer isn't discharging water, check the following: * The drain hose might be clogged or twisted; inspect, clean, or untwist it. * The pump filter could be clogged; clean the pump filter. * Your laundry might be too tightly packed; spread your laundry evenly in the machine.
P
Pamela MuellerSep 3, 2025
How to reduce excessive foam in my Smeg LBP3T94PIT Washer detergent drawer?
- Z
  Zoe WalkerSep 3, 2025
  If you observe excessive foam in the detergent drawer of your Smeg Washer: * You might be using too much detergent. Press the Start/Pause button, then dilute one tablespoon of softener in 1/2 litre of water and pour it into the drawer. Press Start/Pause again after 5-10 minutes. * You might be using the wrong detergent. Ensure you only use detergents specifically produced for automatic Washing Machines.
B
briangardnerSep 5, 2025
Why does my Smeg LBP3T94PIT Washer discharge water immediately after loading?
- C
  Carrie RobinsonSep 6, 2025
  If water discharges as soon as your Smeg Washer is loaded, it's likely because the end of the drain hose is too low. Check that the drain hose is at a suitable height.
J
Julia DaviesSep 8, 2025
Why is my Smeg LBP3T94PIT not cleaning clothes properly?
- L
  Leslie ParkerSep 8, 2025
  If your Smeg Washer isn't washing properly, consider these points: * Your laundry might be too dirty for the selected program; use the program tables to select the most appropriate program. * You might not be using enough detergent; use the amount instructed on the packaging. * There might be too much laundry in your machine; check that you haven't exceeded the maximum capacity for the selected program.
T
Tom ElliottSep 12, 2025
Why are there grey spots on my laundry after washing in my Smeg LBP3T94PIT?
- M
  malonerebeccaSep 12, 2025
  If you see grey spots on your laundry after washing with your Smeg Washer, it could be due to untreated oil, cream, or ointment on your laundry. Use the amount of detergent as instructed on the packaging in the next wash.