Smeg LBW710IT - Page 29

EN -29-
•Yourmachinemayhaveeitherasingleinlet(cold)ordouble
waterinlets(cold/hot)basedonitsspecications.
White-cappedhoseshouldbeconnectedtocoldwaterinletand
red-cappedhosetohotwaterinlet(applicableformachineswith
doublewaterinlets).
•Toeliminatewaterleakagesinpointsofcontact,1or2nutsare
providedinthehosepackage(applicableformachineswithdou-
blewaterinlets).
Fitthesenutstotheendsofnewwaterinlethosesonthesideof
faucet.
•Mountnewwaterinlethosestoa¾˝,threadedfaucet.
•Connectthewhite-elbowendofthewaterinlethosestothe
white-lteredwaterinletvalveontherearsideofthemachineand
thered-elbowendtored-lteredone(applicableformachineswith
doublewaterinlets).
Tightenplasticpartsofthejunctionsusingyourhand.
Inuncertainconditions,havetheconnectionworksbedonebya
qualiedplumber.
•Flowofwaterwithpressureof0,1-1Mpawillallowyourmachine
tooperatemoreefciently.)(0,1Mpapressuremeansthatmore
than8litresofwaterwillowthroughafully-tappedfaucetperone
minute.)
•Ensurethatpointsofcontactdonotleakbytappingthefaucet
completelyaftercarryingmakingtheconnections.
CHAPTER -3: INSTALLATION OF THE MACHINE
(WATER INLET HOSE CONNECTION)
3/4”
10mm