Problem and alarm code Possible cause and solution
Small leak from the appliance
door.
• The appliance is not levelled. Loosen or tighten the adjustable feet
(if applicable).
• The appliance door is not centred on the tub. Adjust the rear foot (if
applicable).
The appliance door is difficult to
close.
• The appliance is not levelled. Loosen or tighten the adjustable feet
(if applicable).
• Parts of the tableware are protruding from the baskets.
The appliance door opens during
the wash cycle.
• The Dry Assist function is activated. You can deactivate the function.
Refer to "Settings".
Rattling/knocking sounds from in‐
side the appliance.
• The tableware is not properly arranged in the baskets. Refer to bas‐
ket loading leaflet.
• Make sure that the spray arms can rotate freely.
The appliance trips the circuit-
beaker.
• The amperage is insufficient to supply simultaneously all the appli‐
ances in use. Check the socket amperage and the capacity of the
meter or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Authorised Serv‐
ice Centre.
Refer to "Before first use", "Daily
use", or "Hints and tips" for other
possible causes.
Once you have checked the appliance,
deactivate and activate the appliance. If the
problem occurs again, contact an Authorised
Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
WARNING!
We do not recommend using the
appliance until the problem has been
completely fixed. Unplug the appliance
and do not plug it in again until you are
certain that it operates correctly.
13.1 The dishwashing and drying results are not satisfactory
Problem Possible cause and solution
Poor washing results.
• Refer to "Daily use", "Hints and tips" and the basket
loading leaflet.
• Use more intensive washing programme.
• Activate the option to improve the washing results of a selec‐
ted programme.
• Clean spray arm jets and filter. Refer to "Care and Clean‐
ing".
ENGLISH 23
To Next Page
Loading...
