Instructions for the user
15
6.2.2 Pan stands
Remove the pan stands and clean them with lukewarm water
and non-abrasive detergent, making sure to remove any
encrustations. Replace them on the cooking hob.
These components must not be washed in the dishwasher.
6.2.3 Flame-spreader crowns
For easier cleaning, the burner caps and flame-spreader
crowns can be removed; wash them with warm water and
non-abrasive detergent making sure to remove any
encrustations and wait until they are perfectly dry.
The burner pins A must be inserted in the housings B in the
burner crown. The holes C in the burner crowns should be slid
over the igniters and thermocouples D on the hob.
6.2.4 Igniters and thermocouples
For correct operation the igniters and thermocouples must
always be perfectly clean. Check them frequently and clean
them with a damp cloth if necessary. Remove any dry
residues with a wooden toothpick or a needle.
After cleaning, dry the appliance thoroughly to prevent water or detergent drips
from interfering with its operation or creating unsightly marks.
To Next Page
Loading...
