Smeg PL8210X - Special Functions: Half Load and Delay

STARTING THE PROGRAM
To start the dishwasher, press the
START/PAUSE
button
(2)
for a few
seconds, until the light of the selected program starts to flash
(confirmation beep).
The light will flash as long as the program is in progress, to indicate that
it is being performed.
END OF PROGRAM
At the end of the program the beeper
sounds briefly and the program
lights 4
and
5
(marked "end") flash.
INTERRUPTION A PROGRAM
To interrupt a program in progress:
•
press the
START/PAUSE
button
(2)
; the light of the program in
progress remains on (confirmation beep);
•
you may now restart the program by pressing button
(2)
again until it
restarts, or change or annul the program (see "
C
HANGING A
PROGRAM
", or "
A
NNULLING A PROGRAM
").
CHANGING A PROGRAM
To change the running program it is necessary:
•
to interrupt the running program (see “
I
NTERRUPTION A PROGRAM
”);
•
select the new program;
•
start the program (see “
S
TARTING THE PROGRAM
”).
13
User instructions