To set the delay
once the program has started
, proceed as follows.
If the program you wish to carry out is the same as the one already
in progress:
•
press the
START/PAUSE
button
(2)
for a few seconds, until the
program
lights 4
and
5
(marked "end") come on;
•
annul the program in progress (see relative section) and wait for the
cycle to come to an end;
•
select the program again;
•
select the delay required;
•
press the
START/PAUSE
button
(2)
to start the new program.
If the program you wish to carry out is different from the one
already in progress:
•
press the
START/PAUSE
button
(2)
for a few seconds, until the
program
lights 4
and
5
(marked "end") come on;
•
change the program;
•
select the delay required;
•
press the
START/PAUSE
button
(2)
to start the new program.
The
dishwahser will pump out the water and restart with the delay set
and the new program.
16
User instructions
To Next Page
Loading...
