User instructions
12
START PROGRAM
To start the dishwasher, press the button of the PROGRAM (2) required
for a few seconds, until the light of the first phase of the selected
program starts to flash (confirmation beep).
As the program runs, the PHASES/PROGRAM lights (7) will indicate the
current cycle status.
The light of the phase in progress will
flash, while the lights of the previous and
subsequent phases remain on.
N.B. during execution of programs which
do not include a prewash, the first
PHASES/PROGRAM light (7) will remain
off.
END PROGRAM
When the program finishes, a buzzer sounds
briefly and all the PHASES/PROGRAM lights
(7) flash.
Press any of the SELECTION PROGRAMS buttons (2), stops the light
flashins, and the dishwasher is now ready to perform a new cycle;
opening and shutting the door or switching the appliance off and on has
the same effect.
INTERRUPTION OF A PROGRAM
In order to interrupt a running program it is necessary:
• press one of the SELECTION PROGRAMS buttons (2);
• keep the button pressed until the PHASES/PROGRAM lights (7)
come on (confirmation buzzer);
• start the program (see “
START PROGRAM”).
To Next Page
Loading...
