User instructions
13
TO CHANGE A PROGRAM
To change the running program it is necessary:
• to interrupt the running program (see “INTERRUPTION OF A PROGRAM”);
• select the new program;
• start the program (see “
START PROGRAM”).
ANNULLING A PROGRAM
To annul the program in progress, it must first be interrupted (see
“I
NTERRUPTION OF A PROGRAM”).
Now press buttons P1+P2 simultaneously and
the first three program lights will come on.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “START PROGRAM”. The program will resume from the point in
which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
The washing cycle will not take place if the dishwasher door is left open
or not properly closed.
To Next Page
Loading...
