Instructions for the user
74
8.7.2 Setting the assisted cleaning cycle
The assisted cleaning cycle can only be activated when the oven is cold.
Once the preparations have been made for the assisted cleaning cycle, proceed
as follows:
• turn the oven function knob to the symbol and the oven thermostat
knob to the symbol
for the Vapor Clean function;
• set a cooking time of 15 minutes using the timer control knob;
At the end of the assisted cleaning cycle, the timer will deactivate the oven
heating elements.
8.7.3 End of the assisted cleaning cycle
The water remaining at the end of the assisted cleaning cycle cannot be left
inside the oven for long (for example overnight).
You are advised to wear a pair of gloves during these processes.
Do not use abrasive sponges on the deflector or self-cleaning panels.
At the end of the cleaning cycle:
• open the door and wipe away the less stubborn dirt with a microfibre cloth.
Use an anti-scratch sponge with brass filaments on more difficult
encrustations (we recommend removing the door to facilitate access to
restricted spaces);
• dry the oven with a microfibre cloth;
• reposition the self-cleaning panels and the oven runners.
For improved hygiene and to avoid food being affected by any unpleasant
odours, we recommend that the oven is dried and the self-cleaning panels are
simultaneously regenerated using a fan function at the maximum temperature
for approximately 60 minutes.
To Next Page
Loading...
Need help?
General
