EasyManua.ls Logo

Smeg SDP20 - 12 Problem Solving

Smeg SDP20
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem Solving
45
12.PROBLEM SOLVING
PROBLEM PROBABLE CAUSE POSSIBLE SOLUTION
The Home Garden’s lamps are
fully on during day time
- The external lighting level is
low and the sensor has set
the lamps to maximum
power-
- No malfunction
The Home Garden’s lamps are
off in the evening
- The lighting period set in the
pro-gram has ended
- No malfunction If you wish to turn on the lamps
anyway, refer to paragraph "9.5 Internal light
key".
The symbol is flashing
- No water in the tank
- The vaporiser is dirty
- Fill the tank as described in Section- "11.1 Filling
the tank"
- Clean the vaporiser, see paragraph "11.3 Clean-
ing the ultrasound vaporiser".
The symbol flashes even if
there is still a little water left in
the tank
- There is always a minimum
amount of water left, which
cannot- be utilised-by the
vaporiser.
- Fill the tank as described in Section- "11.1 Filling
the tank";
- No malfunction
When I press the key, no
vapour is delivered
- The maximum number of
vapour jets allowed by the
circuitry has been exceeded
- The tank has been filled
beyond the maximum level.
- Wait a few minutes and try again
- Empty the tank with a syringe or similar device
as described in paragraph "11.1 Filling the tank"
The tank has been filled
correctly, but the symbol is
still flashing
- You have not pressed the
key on the remote con-trol
- Press the button on the remote control
The symbol is flashing
- The external temperature is
higher than the preset maxi-
mum: the “Cuttings” function
is not required for growing
cuttings.
- You can continue growing cuttings in any case
When I fit the plug in the mains
socket a red point appears on
the left display
- The Home Garden is in
standby
- Switch on the Home Garden as described in par-
agraph "9.2 Standby key"
A blue point appears on the
right display
- The remote control keys are
locked
- To unlock the remote control hold down the
key for a few seconds as described in paragraph
"9.2 Standby key"
The steel side panels are hot
- The cuttings function is acti-
vated
- The external temperature is
lower than the set tempera-
ture-: the Home Garden is
heating its internal micro-cli-
mate
- Do not touch the surface underneath the pots
with your bare hands.
- No malfunction

Related product manuals