4. At the end of the Vapor Clean function,
STOP flashes on the display and a
buzzer will sound that can be
deactivated by opening the door or
pressing/rotating one of the two knobs.
Setting timed Vapor Clean
It is possible to program the Vapor Clean
start time, like any cooking function.
1. After selecting the Vapor Clean
function, press the programming knob.
The display will show the current time
and the temperature, and the
indicator light will come on.
2. Turn the programming knob to set the
time you wish Vapor Clean to finish.
3. Press the programming knob to confirm
the values entered. The
, and
indicator lights turn on steadily and
the appliance then waits for the set start
time to begin the Vapor Clean cycle.
End of Vapor Clean
1. Open the door and wipe away the less
stubborn dirt with a microfibre cloth.
2. Use a non-scratch sponge with brass
filaments on hard to remove deposits.
3. In case of grease residues use specific
oven cleaning products.
4. Remove the residual water inside the
oven.
5. Where fitted, reposition the self-
cleaning panels and the rack/tray
support frames.
For greater hygiene and to avoid foods
taking on unpleasant odours:
• We recommend drying the inside of the
oven with a fan assisted function at
160°C for around 10 minutes.
• Where the self-cleaning panels are
fitted, we recommend drying the inside
of the oven with a simultaneous catalysis
cycle “Regeneration of self-cleaning
panels (catalysis cycle) (on some models
only)”).
We recommend wearing rubber
gloves for these operations.
We recommend removing the
door in order to make the manual
cleaning of the parts that are
difficult to reach easier.
To Next Page
Loading...
Need help?
General
