What to do if Smeg ST317AT does not take in water?
If your Smeg Dishwasher isn't taking in water correctly, first ensure that the water connections are properly made and the water intake tap is fully open. Also, inspect the filter for any blockages. If, after checking these, the issue continues, further assistance is needed.
What to do if Smeg Dishwasher does not pump out water?
If your Smeg Dishwasher isn't pumping out water properly, check the drain hose to make sure it's not bent or squeezed shut. Also, make sure the siphon and filter aren't blocked. If the problem continues after checking these, further assistance is needed.
What to do if Smeg Dishwasher E2 error occurs?
If the system limiting the water level inside your Smeg Dishwasher has been tripped, interrupt the current program and turn the dishwasher off. Then, turn it back on, select a program, and start a new washing cycle. If the problem continues, further assistance is needed.
General| Type | Freestanding |
|---|---|
| Number of Place Settings | 13 |
| Width | 60 cm |
| Depth | 60 cm |
| Annual Energy Consumption | 262 kWh |
| Color | Stainless Steel |
| Noise Level | 47 dB |
| Delay Start | Up to 24 hours |
| Half Load Option | Yes |
| Wash Programs | Soak, ECO, Delicate |
To Next Page
