Instructions for the installer
7
4. INSTALLING THE APPLIANCE
The appliance must be installed by a qualified engineer in compliance with the relevant regulations.
Depending on the type of installation, it belong to class 1 (Fig. A) or class 2 - sub-class 1 (Fig.B-C).
It may be installed against walls one of which must be higher than the worktop surface and at least 50
mm from the side of the appliance, as shown in the installation class drawings A and B. Any wall
cupboards or extractor hoods installed above the appliance's worktop must be at least at a distance of
750 mm above the worktop.
A) B)
Built-in appliance Free-standing appliance
C)
4.1 Wall fixing
In order to avoid the cooker tipping over it must be attached
to the wall by means of a chain, as described below:
• Stretch out horizontally the chain attached to the cooker
• so that the other end touches the wall.
• Draw a mark on the wall in the position where the hole is
to be drilled.
• Drill the hole, insert a wall plug and attach the chain.
• Move the cooker up against the wall.
To Next Page
