Cleaning and maintenance
79
3. To reassemble the door, put the hinges in
the relevant slots on the front of the oven,
making sure that the grooved sections
(A) are resting completely in the slots.
Lower the door and once it is in place
remove the pins from the holes in the
hinges.
Cleaning the door glazing
The glass in the door should always be kept
thoroughly clean. Use absorbent kitchen
roll. In case of stubborn dirt, wash with a
damp sponge and an ordinary detergent.
1. Remove the internal glass pane by
pulling the rear part gently upwards,
following the movement indicated by the
arrows (1).
2. Then, pull the front part upwards (2). This
way, the 4 pins attached to the glass
detach from their housings in the oven
door.
3. Remove the intermediate glass pane by
lifting it upwards.
We recommend the use of
cleaning products distributed by
the manufacturer.
To Next Page
