Cleaning and maintenance
34
Removing and installing the oven seal
To remove the oven seal:
• Unhook the clips in the 4 corners and in
the centre, then pull the oven seal.
To install the oven seal:
• Hook the clips in the 4 corners and in the
centre onto the oven seal.
Oven seal maintenance tips
The seal should be soft and elastic.
To keep the oven seal clean, use a non-
abrasive sponge and lukewarm water to
wash it.
What to do if...
The appliance does not work.
• The circuit breaker is faulty: look in the
fuse box and check that the circuit
breaker is in working order.
• Power cut: check whether the kitchen
light works.
The gas burner does not ignite.
• Power cut or damp ignition plugs: light
the gas burner with a gas lighter or a
match.
The oven does not heat up.
• Faulty fuse: check and, if required,
replace the circuit breaker.
• The function knob has not been set: set
the function knob.
All dishes that are prepared in the oven
burn within an extremely short period of
time.
• Faulty thermostat: call the Authorised
Assistance Centres.
The door panel steams up when the oven
is hot.
• Normal occurrence caused by the
difference in temperature: this has no
effect on oven performance.
If the problem has not been
resolved or in the case of other
types of fault, contact your local
technical support centre.
To Next Page
Loading...
