How to fix Smeg Washer/Dryer that does not start?
If your Smeg Washer/Dryer isn't starting, make sure the plug is properly connected to the socket, the door is securely closed, and the “Start/Pause” button has been pressed.
Why is my Smeg WDI14C7 Washer/Dryer not drying my laundry?
If your Smeg Washer/Dryer isn't drying laundry, check that the water tap is turned on, the load of laundry isn't excessive, the drying time is long enough, and the appropriate drying time is selected. If the appliance still does not dry the laundry, call the Service Centre to have the fan and drying ducts cleaned to remove any fluff deposits.
Why Smeg WDI14C7 Washer/Dryer does not spin?
If your Smeg Washer/Dryer does not spin, it may be because the anti-imbalance safety device has tripped because the laundry is not evenly distributed in the drum. If laundry is still wet at the end of the cycle, rearrange it in the drum by hand and repeat spin programme only.
How to remove detergent traces from laundry in Smeg WDI14C7 Washer/Dryer?
If there are traces of detergent on your laundry after using your Smeg Washer/Dryer, it could be due to phosphate-free detergents containing substances with low water solubility. Select the Rinse programme or brush the laundry.
Why is my Smeg WDI14C7 not filling with water?
If your Smeg Washer/Dryer isn't filling with water, check the following: - Ensure the plug is properly connected to the socket. - Make sure the door is securely closed. - Verify the water tap is turned on. - Check that the water intake hose filters are not fouled and the hose isn't trapped or kinked.
Why is my Smeg WDI14C7 vibrating so much during spins?
Strong vibrations during spins may occur if the appliance is not properly leveled, is too close to walls or kitchen units, or the internal unit on flexible mounts is not locked in position. Check these to resolve the issue.
What to do if there is water on the floor near my Smeg Washer/Dryer?
If you find water on the floor near your Smeg Washer/Dryer, check that the water intake hose fittings are not loose and that the end of the drain hose is still correctly positioned.
What to do if water is not pumped out of my Smeg WDI14C7 Washer/Dryer?
If water is not being pumped out of your Smeg Washer/Dryer, check that the drain hose is not kinked and the drain pump is not fouled.
Why is there too much foam in my Smeg WDI14C7?
Too much foam in your Smeg Washer/Dryer could be due to using a detergent not recommended for automatic washing machines or using a quantity greater than stated in the manual. Check that the detergent used is recommended for automatic washing machines and not for hand washing and that the quantity used is as stated in the manual and no more.
Why are the washing results unsatisfactory with my Smeg WDI14C7?
Unsatisfactory washing results from your Smeg Washer/Dryer could be due to too little or unsuitable detergent, difficult stains not pre-treated, incorrect temperature settings, or an overloaded basket.
Guidelines for disposing of packaging materials responsibly.
Procedures for rendering old appliances unusable and their disposal.
Recommendations for eco-friendly operation and use of the appliance.
Crucial safety guidelines for appliance installation, operation, and maintenance.
Step-by-step instructions for replacing the fuse in the appliance's power plug.
Guidelines for electrical connection when the appliance uses a plugless supply cord.
Steps for unpacking the washer-dryer and removing transport fixings.
Instructions for correctly positioning and levelling the appliance.
How to connect the appliance to the cold and hot water supply taps.
Instructions for connecting the drain hose to a drain pipe or sink.
Procedures for safely connecting the appliance to the electrical supply.
Overview of the appliance's control panel, display, buttons, and indicators.
Guidelines for sorting laundry and preparing it for washing.
How to safely open the appliance door after a wash cycle.
Advice on loading the correct amount of laundry for efficient washing.
Instructions on how to load laundry evenly into the drum.
How to add detergent and fabric conditioner to the correct compartments.
Guidance on using the correct amount of powder detergent.
Guidance on using the correct amount of liquid detergent.
How and when to add descalers to the appliance.
Reference to the Programme Table for selecting wash programmes.
Steps to turn on the appliance and select a wash programme.
How to select and confirm various washing options like Prewash, Intensive, etc.
Explanation of the Delay Timer and how to set it.
How to start the selected washing programme.
Procedures for pausing, changing, or restarting a washing cycle.
What happens when a programme finishes and how to unload laundry.
How to activate and deactivate the child lock feature.
How to open the door in case of power failure or emergency.
General information and precautions for using the drying function.
How to perform an extra drying cycle if laundry is still damp.
How to use the combined wash and dry programmes.
How to use the drying function independently of the washing cycle.
How to pause or change a drying cycle.
How to run the cleaning programme for the drying circuit.
How to clean the exterior surfaces of the washer-dryer.
Instructions for cleaning the appliance drum and removing rust marks.
How to check and clean the door seal for debris.
Steps to clean the drain pump if it becomes blocked.
How to remove and clean the detergent dispenser drawer.
How to clean the filters in the water intake hose.
Checks to perform if the appliance fails to start operation.
Checks to perform if the appliance is not filling with water.
Explanation for why no water may be visible in the drum.
Checks to perform if water is not being drained from the appliance.
Explanation for water remaining after specific rinse programmes.
Checks for issues with continuous water intake or drainage.
Checks to perform if the appliance vibrates excessively during spins.
Checks for issues related to excessive foam formation.
Checks to perform if water is leaking onto the floor.
Checks for issues with fabric conditioner not being used or compartment retaining water.
Reasons for the appliance not spinning and how to resolve.
How to empty water from the drum in case of power failure or appliance breakdown.
Reasons for laundry not being spun correctly and how to fix.
Possible causes for detergent residues on clothes after washing.
Checks to perform if laundry is not drying properly.
Common reasons for poor washing or drying results.
Explanation of error codes shown on the appliance display.
Specifies the minimum dimensions for the installation cabinet.
Instructions on how to attach the front panel to the machine.
How to use the template to mark holes for panel attachment.
Steps for drilling holes and attaching panel elements to the machine.
How to adjust the hinges for proper panel alignment.
Instructions for placing the machine within the cabinet and ensuring clearance.
How to fit the baseboard, ensuring access to the drain pump.
General| Water consumption per cycle | 47 L |
|---|---|
| Energy consumption washing per cycle | 0.95 kWh |
| Door color | White |
| Loading type | Front-load |
| Product color | Black, White |
| Built-in display | Yes |
| Appliance placement | Built-in |
| Door panel included | No |
| Drum capacity | 5 kg |
| Delay start (max) | 24 h |
| Spin-drying class | - |
| Maximum spin speed | 1400 RPM |
| Noise level (spin) | 72 dB |
| Noise level (wash) | 56 dB |
| Number of washing programs | 15 |
| Washing class | A |
Weight and Dimensions| Depth | 575 mm |
|---|---|
| Width | 596 mm |
| Height | 820 mm |
To Next Page
