1. Assemble Hose To Tank
IMPORTANT: Do not attempt to heat or alter
hose, hose nut, or barb prior to assembly.
1. Align hose barb tabs, push hose barb into tank
until it stops (See Figure A).
2. Slide hose nut into place and turn clockwise to
tighten. (See Figure B).
NOTE: Do not use tools to tighten hose nut.
Figure A Figure B
3. Assemble Shut-o to Wand
Screw on Wand Assembly to end of Shut-o
and tighten securely. (See Figure D)
2. Assemble Wand & Nozzle
Place nozzle onto the end of the
wand assembly and tighten securely.
(See Figure C)
Con guration for
nozzle tip sprayers
Figure C
Figure D
SETTING UP YOUR BLEACH SPRAYER
190447
QUICK START GUIDE
To Next Page
Need help?
General
