Smith R200 - User Manual

1. Assemble Hose To Tank
IMPORTANT: Do not attempt to heat or alter
hose, hose nut, or barb prior to assembly.
1. Align hose barb tabs, push hose barb into tank
until it stops (See Figure A).
2. Slide hose nut into place and turn clockwise to
tighten. (See Figure B).
NOTE: Do not use tools to tighten hose nut.
Figure A Figure B
3. Assemble Shut-o to Wand
Screw on Wand Assembly to end of Shut-o
and tighten securely. (See Figure D)
Figure D
2. Assemble Wand & Nozzle
Place nozzle onto the end of the
wand assembly and tighten securely.
(See Figure C)
Conguration for
nozzle tip sprayers
Figure C
SETTING UP YOUR R200 SPRAYER
190462
QUICK START GUIDE

Summary

Quick Start Guide

Assemble Hose To Tank

Connect the hose to the sprayer tank, aligning barb tabs and tightening the hose nut securely without tools.

Assemble Wand & Nozzle

Attach the nozzle to the end of the wand assembly and tighten it securely.

Assemble Shut-off to Wand

Screw the wand assembly onto the shut-off valve and tighten it securely.

Parts Included with Your R200 Sprayer

Component Identification

Lists and identifies all parts included with the R200 sprayer, such as wand, nozzle, and shut-off assembly.

Manual and Support Information

Details about the accompanying manual, warranty card, and contact information for customer support.

Smith R200 Specifications

General

Brand	Smith
Model	R200
Category	Paint Sprayer
Language	English