Smith Little Torch - Default Chapter; Table of Contents

TABLE OF CONTENTS
SECTION 1 − SAFETY PRECAUTIONS - READ BEFORE USING 1..........
1-1. Symbol Usage 1..................................................
1-2. Oxy-Fuel Welding, Cutting, Brazing, Heating Hazards 1................
1-3. California Proposition 65 Warnings 5.................................
1-4. Principal Safety Standards 6........................................
SECTION 2 − INTRODUCTION 7........................................
SECTION 3 − HAZARDOUS EVENTS 7..................................
SECTION 4 − HAZARDS OF RECOMPRESSING PURE OXYGEN 7..........
SECTION 5 − THE TORCH SYSTEM 8...................................
5-1. Torch 8..........................................................
5-2. Gases 8..........................................................
5-3. Tips 8............................................................
5-4. Repairs/Replacement Of Hose 8....................................
SECTION 6 − FREQUENTLY ASKED QUESTIONS 9.......................
SECTION 7 − USING TORCH WITH DISPOSABLE-TYPE CYLINDERS 10....
7-1. Disposable Compressed Gas Cylinders 11............................
7-2. Installing Regulators On Cylinders − Models 239-499B And 239-500B 11..
7-3. Installing Hoses 11................................................
7-4. Activating The System 12..........................................
7-5. Purging The System 12............................................
7-6. Testing The Equipment For Leaks 12.................................
7-7. Selecting And Installing A Tip 12.....................................
7-8. Lighting Procedures (When Using Disposable Cylinders) 12.............
7-9. Extinguishing The Torch Flame 13...................................
7-10. Shutting Down The System 13......................................
7-11. Bleeding The System 13...........................................
SECTION 8 − USING TORCH WITH HIGH PRESSURE CYLINDERS 13.......
8-1. Industrial-Type Cylinder Information 13...............................
8-2. Installing Regulators 14............................................
8-3. Installing Hoses 14................................................
8-4. Activating The Regulators 14........................................
8-5. Adjusting Regulator Pressures And Purging The Hoses 15..............
8-6. Testing The Equipment For Leaks 15.................................
8-7. Selecting And Installing A Tip 16.....................................
8-8. Lighting /Adjusting Torch When Using Acetylene Or Hydrogen Fuel 16...
8-9. Lighting And Adjusting Torch When Using Alternate Fuel Gases 17.......
8-10. Extinguishing The Torch Flame And Securing Equipment 17.............
8-11. Shutting Down The System 17......................................
8-12. Bleeding The System Of Gases 17..................................
SECTION 9 − HOSE REPLACEMENT 18.................................
9-1. Removing Old Hose 18.............................................
9-2. Installing New Hose 18.............................................
SECTION 10 − REGULATORS 19.......................................
SECTION 11 − TECHNICAL DATA 20....................................
11-1. Tip Specifications 20...............................................
11-2. Fuel Gas And Flame Characteristics 21..............................
11-3. Flame And Heat Placement BTU Output Per Cubic Ft Of Fuel Burned 21.
11-4. Cylinder Valve Identification For Regulator Selection 21.................
SECTION 12 − ACCESSORIES 22.......................................
WARRANTY