Level 1
®
H-1000 Operator's & Service Manual
About This Manual 2
Purpose 2
Concept 2
System Features 3
Filter with Gas Vent 3
Temperature Control 4
Flanking I.V. Pole Brackets 4
Unpacking and Set up 4
System 1000 Hardware 6
Power and Alarm Test Panel 6
Display Panel 7
Interlocks 8
Accessories: System 1025 Pressure Infusers 9
Set-up and Use 9
Disposables: Set up and Performance 12
Setting Up Disposable Sets 12
Priming Disposable Sets 13
Filter with Gas Vent Replacement in IV Disposable Sets 13
Trouble Shooting 15
Trouble Shooting Slow Flow Rates 16
Testing 17
Add Water Alarm 17
Check Disposables Alarm 17
Water Over Temperature Alarm 18
Alarm Testing 18
Performance Testing 18
Earth Leakage 19
Ground Continuity 19
Dialectric Strength 20
Maintenance 20
Maintenance and Testing Log 22
Service 22
Warranty Service 22
Non-Warranty Service 24
Specifications 24
Physical Specifications 24
Electrical and Environmental Specifications 24
Accessory, Maintenance and Calibration Part Numbers 25
Parts and Electrical Schematics 25
International Symbols 28
No part of this manual may be reproduced in any form without prior written permission from Smiths Medical ASD, Inc.
(Smiths Medical)
Level 1 and Smiths design mark are trademarks of the Smiths Medical family of companies. The symbol ® indicates the
trademark is registered in the U.S. Patent and Trademark office and certain other countries.
*Cover pictures the H-1025, a combination of the H-1000 Fluid Warmer and two accessory H-2 Pressure Infusion Chambers.
The products described are covered by one or more of the following U.S. Patent Nos. 4,759,749; 4,878,537; 4,900,308;
5,063,994; 5,097,898; and 4,678,460; other patent(s) pending.
© 2006 Smiths Medical family of companies. All rights reserved.
Operator’s Manual Part #4533801 (Rev 001) 2006/08
To Next Page
Loading...
