TRAK MODEL 9100 MODULAR FREQUENCY/TIME SYSTEM
TM4400013 Rev, D
iv
CHAPTER 5
REPLACEMENT PARTS LIST
5-1 General 5-1
LIST OF ILLUSTRATIONS
Figure Page
Model 9100 Modular Frequency/Time System iii
1-1 Model 9100 Panel Views 1-2
1-2 Model 9100 Functional Block Diagram 1-3
2-1 Model 9100 Rear Panel 2-2
2-2 Model 9106 Digital Distribution (DDM) Switch Locations 2-5
2-3 Model 9107 Frequency Distribution Module (FDM) Jumper Locations 2-6
2-4 Model 9111 Telecommunications Generator (TEL) Switch and Jumper Locations 2-7
3-1 Model 9100 Front Panel 3-1
3-2 Model 9101 GPS Reference Front Panel 3-2
3-3 Model 9106 Digital Distribution DDM Front Panel 3-3
3-4 Model 9111 Telecom Signal Generator Front Panel 3-4
3-5 Model 9107 Frequency Distribution FDM Front Panel 3-5
3-6 Model 9104 Fault Sensing and Switching Unit (FSU) Front Panel 3-6
3-7 Model 9120-2 Power Supply Front Panel 3-7
LIST OF TABLES
Table Page
1-1 Interface Cables for EMC Compliance 1-4
1-2 Output Characteristics, References 1-5
1-3 Output Characteristics, RS-232 and TOD 1-7
1-4 Output Characteristics, Alarms 1-7
1-5 I/O Characteristics, 10BaseT, NTS 1-7
1-6 Input Characteristics, GPS Antenna 1-7
1-7 Oscillator Characteristics 1-8
1-8 Major and Minor Alarm Conditions 1-10
2-1 Rear Panel Connectors, Fuse, and Switch 2-2
2-2 10Base T Connections 2-3
2-3 Alarms 2-3
2-4 TOD Outputs 2-4
2-5 RS-232 Outputs 2-4
2-6 Reference Outputs 2-4
2-7 DDM Output Signal Switch Positions 2-5
2-8 FDM Input Signal Jumper Positions, T1 2-6
2-9 TEL Framing Format Switch Positions, T1 2-8
2-10 TEL Line Length Compensation Switch Positions, T1 2-8
2-11 TEL Framing Format Switch Positions, E1 2-8
2-12 TEL RS-422 Clock J1 Connections 2-9
2-13 TEL Framed J2 Connections 2-9
3-1 Request Command List 3-12
3-2 Setup Commands List 3-12
5-1 Replacement Modules 5-1
To Next Page
Loading...