10
Step 3 - Check the system
Before using the winch, verify the following:
• Wiring to all components are correct. All loose wires are tight.
• There are no exposed wiring or terminals.
• Check winch for proper operation. The wire rope should spool in and out in the
direction indicated on the switch.
Step 4 – Winch operation
To free spool pull knob out and twist approx ½” (Fig A)
When powering in make sure winch is engaged (twisting know back and knob
is all of the way back in.
Push “IN” button on remote. (Fig B)
(Fig A) (Fig B)
To Next Page
Loading...
Need help?
General
