EasyManua.ls Logo

Smittybilt XRC 2 - Cut, Burn, and Damage Prevention; Cut and Burn Hazards; Equipment Damage Prevention

Smittybilt XRC 2
17 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
CUT AND BURN HAZARD
Failure to observe these instructions could lead to minor or moderate injury.
To avoid injury to hands and fingers:
Always wear heavy leather gloves when handling a rope.
Never let rope slip through your hands.
Always be aware of possible hot surface at winch motor, drum or rope during
or after winch use.
AVOID WINCH AND EQUIPMENT
DAMAGE
Always avoid side pulls which can pile up rope at one end of the drum. This
can damage rope or winch.
Always ensure the clutch is fully engaged or disengaged.
Never use winch to tow other vehicles or objects. Shock loads can
momentarily exceed capacity of rope and winch.
Always avoid “powering out” for extended distances. This causes excess heat
and wear on the winch motor and brake.
Always use care to not damage the vehicle frame when anchoring to a
vehicle during a winching operation.
Never “jog” rope under load. Shock loads can momentarily exceed capacity of
rope and winch.
Never use winch to secure a load during transport.
Never submerge winch in water.
Always store the remote control in a protected, clean, dry area.
Always double line or pick distant anchor point when rigging. This maximizes
pulling power and avoids overloading the winch.

Related product manuals