WARNING:
Keep fingers clear of the pivoting mechanism when folding or unfolding the scooter. Make sure others are standing clear.
Failure to properly secure the quick-release lever may cause the handlebar to telescope up or down while riding and may cause you to lose control and fall.
ASSEMBLY AND SET-UP
1. To release the folding mechanism, place the scooter on the
ground, push the release lever down to unfold the scooter.
2.Using the 5 mm Allen Wrench loosen the handlebar clamp.
4.Using the 5 mm Allen Wrench tighten the handlebar clamp.
3. Insert the handlebar.
5. To adjust the height of the handlebar, open the quick-release
lever and slide the handlebar to the desired position and resecure
the quick-release lever to lock into place.
6.The tension of the quick-release lever can be adjusted by
manually tightening or loosening the Allen bolt. Be careful
not to overtighten. You should always be able to open and
close the quick-release lever by hand and the handlebar
should slide freely when the quick-release is open.
3
To Next Page
Loading...
