ASSEMBLY AND SET-UP
Using a 5 mm Allen wrench, check that the collar clamp bolts are tightened securely.
This item is tightened and quality inspected at the factory, but there is a slight chance that the effects of shipping or handling may have caused the bolt to loosen.
WARNING: Failure to properly install and tighten the collar clamp may cause the rider to lose control and fall. If you are having difficulty understanding
these instructions, please contact SmooSat Customer Service for assistance.
Loose Parts
Check and secure all fasteners before every ride. Make sure the
collar clamp, quick-release lever, folding mechanism are locked
properly in place before riding.
Replacement Parts
Replace worn or broken parts immediately.
Contact support@ismoosat.com.
Safety Gear
Always wear proper protective equipment, such as an approved
safety helmet, elbow pads and kneepads. Always wear shoes
(lace-up with rubber soles) and keep shoelaces tied and out of
the way of the wheels. Never ride barefooted or in sandals.
Be Careful!
You will see people on TV and maybe even people you know doing
tricks and stunts. These are people who have been practicing on
scooters for a very long time. Don’t try something until you are
ready. Avoid steep inclines and don’t ride too fast — you can lose
control and fall. Skateboard parks are not designed for scooters.
Never ride in traffic or on the street and watch your surroundings
for pedestrians, bikers, boarders and skaters.
Maintain a hold on the handlebar at all times.
PRE-RIDE CHECKLIST
4
To Next Page
Loading...
