WAVE SHAPING
The wave knob controls the initial wave shape from the VCO. In the anti-clockwise position a saw tooth is
generated, in the clockwise position a pulse is generated, between the two positions the wave shape alters from
sawtooth through various sawtooth/squarewaves to a 2% pulse. The waveform is fully variable with no fixed point.
The mod knob controls the amount of triangle modulation (from the VCLFO) or envelope modulation routed to the
wave shape. Pulse width modulation can be created using this method.
VCO PATCH POINTS
This is a hard sync input used to reset the VCO waveform using a second oscillator. A wide range of frequencies,
waveshapes and levels will determine the type of sync generated.
This is the main control voltage input for the VCO frequency and has logarithmic characteristics of one volt per
octave, this should be your input from a keyboard/controller.
This is simular to the VCO 1/V input but should be used for external modulation, (eg: LFO, sample and hold,
ENV).
6
To Next Page
Loading...