MAKING ADJUSTMENTS OR REPAIRS TO THE ENGINE
Excessively high operating speeds increase risk of injury and damage to
engine. Excessively low speeds produce heavy load on engine.
• DO NOT attempt to alter pre-set governed speed. Engine governor is factory
set to supply optimum output horse power (HP) when running at governed speed.
•
DO NOT modify engine in any way.
TESTING SPARK PLUG FOR SPARK
• DO NOT check spark plug for spark by removing from head cylinder.
• Disconnect spark plug wire from spark plug and cover tip with
non-conducting material such as electrical tape to prevent it from coming in
contact with spark plug, fuel tank or other parts of the engine where damage
can result from sparking.
• Replace a defective spark plug only with authorized parts.
• Use approved spark plug tester.
TRANSPORTING OR REPAIRING EQUIPMENT
RISK OF PROPERTY DAMAGE WHEN TRANSPORTING PRESSURE WASHER
Turn off the pressure washer before transport. Use caution when moving the
pressure washer. Oil can leak or spill and could result in fire or breathing hazard,
serious injury or death. Oil leaks will damage carpet, paint, or other surfaces in vehi-
cles or trailers. Be sure to use the handle to lift or carry the pressure washer.
• The wheel kit is not designed for over-the-road use. Pressure Washer
must be transported in a vehicle or on a trailer.
• Unit is heavy. Take care when lifting or moving unit.
• Transport or repair with fuel tank
EMPTY to prevent an unintentional spark
igniting fuel vapors resulting in a fire or an explosion.
• Transport or repair with spark plug wire
DISCONNECTED.
10
To Next Page
Loading...
Need help?
General
