• DO NOT overfill fuel tank. Slowly add unleaded gasoline (A) to fuel tank (B). Use
extreme caution not to fill fuel above baffle
(C). This allow appropriate space for
fuel expansion.
STARTING
PRIOR TO STARTING THE PRESSURE WASHER, MAKE SURE THAT YOU HAVE:
1. Selected a proper size nozzle for the job at hand (see "SELECTING THE RIGHT
NOZZLE")
2. Attached the Pressure Washer to the water source and turned on the source
(see "ATTACHING THE PUMP TO WATER SUPPLY").
DO NOT run the pump without the water supply connect-
ed and turned on. Damage to the Pressure Washer resulting from failure to
follow this instruction
WILL void the warranty.
3. For your protection, wear protective safety glasses (provided).
4. Move the Pressure Washer
OUTSIDE in a fully VENTILATED area.
5. Place the Pressure Washer on a
FLAT and level surface and close to the work-
ing surface. Keep a minimum of
5 ft. (1.5 meters) CLEARANCE on all sides of
the engine including top. Face the engine exhaust outlet
AWAY from dwellings.
6. Make sure the Throttle lever is
set to the
“FAST” position (left).
7. Slide the Fuel Valve lever to
“ON” position (right) to allow the fuel to flow to
the engine.
8. Slide the Choke Lever to
“START” position (left).
9. Turn the Engine
ON/OFF switch clockwise to ON position.
10.
Point nozzle to a safe direction and squeeze the Spray Gun
trigger to allow for easier
engine start.
20
FILL LINE
To Next Page
Loading...
