10
Editing a Preset
Edit PSET function gives user ability to edit stored PSETS on wrench.
1. From Preset screen to be edited, press and hold UNITS U button for 3 seconds.
2. CHANGE PRESET screen is displayed.
3. Highlight EDIT selection using UP /DOWN buttons then press ENTER button.
4. MINIMUM TORQUE or ANGLE screen is displayed. Value can be changed by pressing
UP /DOWN buttons. Once desired target torque or angle value has been set, press
ENTER button.
5. MAXIMUM TORQUE or ANGLE screen is displayed next. Value can be changed by pressing
UP /DOWN buttons. Once desired target torque or angle value has been set, press
ENTER button.
6. BATCH COUNT screen is displayed next. Value can be changed by pressing UP /DOWN
buttons. Once desired batch count value has been set, press ENTER button.
7. PSET target screen is displayed labeled with same PSET number.
Note: Pressing ENTER button while EXIT menu selection is highlighted will exit without editing
PSET.
Deleting a Preset
Delete PSET function allows user to remove stored presets from wrench.
1. From Preset screen to be deleted, press and hold UNITS U button for 3 seconds.
2. CHANGE PRESET screen is displayed.
3. Highlight DELETE menu selection using UP /DOWN buttons and press ENTER button.
4. Target screen is displayed and deleted PSET is no longer available for selection.
To Next Page
Loading...
Need help?
General
