What to do if torque reading is out of spec on Snap-On TECHANGLE STEEL ATECH3FS250?
If the torque reading is out of specification, it could be due to needing a recalibration, so recalibrate the tool. Alternatively, the incorrect head length might have been entered. In this case, enter the correct offset head length.
How to fix Snap-On TECHANGLE STEEL ATECH3FS250 Power Tool that does not turn on?
If your Snap-On Power Tool doesn't turn on when you press the power button, it could be due to dead or missing batteries, so replace them. If that doesn't solve the issue, a software glitch might be the cause. Try cycling the power using the end-cap.
Why Snap-On TECHANGLE STEEL ATECH3FS250 wrench didn't retain settings after battery replacement?
If your wrench didn't retain settings after the batteries were removed, it's likely because the batteries were removed before the settings were saved in non-volatile memory. To resolve this, clear the data, re-enter your settings, and then press and hold the POWER button to power down the wrench before removing the batteries.
What to do if Snap-On Power Tool displays torque or angle when no torque is applied?
If your wrench displays torque or angle readings when no torque is being applied, there are several potential causes. First, ensure the wrench is placed on a stable surface without any torque applied, and then press the POWER button to re-zero the wrench. Other causes may include a low or dead battery (replace batteries), the wrench being over torqued or improperly calibrated (in which case recalibrate the wrench), torque applied while zeroing (remove torque and re-zero), the wrench moving during zeroing (place wrench on stable surface), or the POWER button being pressed during angle zeroing (place wrench on stable surface and press POWER button to re-zero). Also, it could be that over 125% of full scale torque was applied (cycle power using POWER button and recalibrate), the wrench was ro...
Over-torquing, force against flex stops, or out-of-calibration angle wrench can cause breakage or injury.
Plastic handle is not insulated; do not use on live electrical circuits.
Lists core operational functions like Set, Track, Peak Hold, and Memory.
Details torque, angle accuracy, and preset ranges.
Provides an overview of basic operations and controls.
Details the steps for powering on the wrench and initial zeroing.
Step-by-step guide for setting torque, applying, and recalling peak torque.
Step-by-step guide for setting angle, applying torque, and recalling peak angle.
How to enter adapter/extension length for calibration correction.
Overview of configuring 10 preset torque or angle settings.
Steps to add new torque/angle presets and edit existing ones.
Lists common issues, causes, and resolutions for the wrench.
General| Resolution | 0.1 ft-lb |
|---|---|
| Warranty | 1 year |
| Torque Range | 5-250 ft-lbs |
| Torque Accuracy | ±2% |
| Angle Accuracy | ±1° |
| Drive Size | 1/2 in |
| Operating Temperature | 14°F to 122°F (-10°C to 50°C) |
| Storage Temperature | -4°F to 140°F (-20°C to 60°C) |
To Next Page