EasyManuals Logo

Snap-On CT8810B User Manual

Snap-On CT8810B
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
ZCT8810BCE Rev. C (03/20)
Storage
Do not expose your battery pack to water or rain; this
could damage the battery pack.
Fully charge the battery before placing it in storage. For
optimum life, store the all Lithium-Ion batteries at room
temperature away from moisture. Permanent capacity
loss can result if batteries are stored for a long period at
high temperature, over 120°F(49°C).
Maintenance
Service
Service of a tool requires extreme care and knowledge.
Service should be performed only by a qualified service
technician.
Always check tool for damaged parts before use.
Replace or repair damaged parts before use. Check
alignment of moving parts. Binding of moving parts or
broken parts may alter operation.
Have damaged parts properly repaired or replaced by an
Authorized Service Center.
Do not use tool if switch does not turn it on and off.
Maintain tools. Keep tools dry, clean and free of oil and
grease for better and safer performance.
For the location of the nearest Snap-on repair center, call
Snap-on customer service at 1-877-762-7664.
(North America Only)
Northern Repair Center
3011 E Route 176
Crystal Lake IL 60014
(Outside North America)
Refer to address on Declaration of Conformity
When charging or discharging a lithium-ion battery over
a short period of time, the internal temperature of the
battery pack increases substantially. This is normal.
Under ideal working conditions the useful life of a lithium-
ion battery pack is around 1000 charge/discharge cycles.
Improper care and maintenance shortens battery life and
the amount of time the battery holds a charge.
Use only with Snap-on charging equipment that
specifies a CTB series battery pack.
Avoid short circuiting the battery pack. Permanent
damage to the pack can occur from high current
discharge.
Unplug charger from outlet before starting the
disassembly procedure.
Remove the battery pack from the tool before starting
the disassembly procedure. Short-circuiting the
battery pack can cause fire or personal injury.
Use safety equipment. Always wear eye protection.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Snap-On CT8810B and is the answer not in the manual?

Snap-On CT8810B Specifications

General IconGeneral
BrandSnap-On
ModelCT8810B
CategoryPower Tool
LanguageEnglish

Related product manuals