1-7
IInnttrroodduuccttiioonn
C Hour Meter (On Sides)
Registers recovery compressor run time to guide master filter
maintenance. For additional information refer to Chapter
3Master Filter.
D Master Filter
Consists of a 10 micron particulate filter and desiccant to
remove moisture. For additional information refer to Chapter
3Changing the Master Filter.
E Scale
Electronically measures the amount of refrigerant dispensed,
recycled, and remaining in the recovery tank.
Oil Separator (Internal)
Removes oil and other contaminants from the refrigerant being
recycled.
F Service Ports (On Sides)
The yellow service hose from the gauge set attaches to the
service port.
G Oil Drain Valve
Used to drain recovered oil from unit after every recover/recycle
operation.
H Oil Cup
Used to measure recovered oil.
Figure 1-2: Typical Port Designation
To Next Page
Loading...