Snap-On ETHOS Edge - Getting Started with ETHOS Edge; Battery Installation and Powering On; Wi-Fi Configuration and Connection; Basic Operation and Manual Access

GETTING STARTED
This side up.
A
Quick Lookups
OBD-II/EOBD
To ol s
Scanner
Previous Vehicle
and Data
Q
uick Lo
okups
O
BD-II
/
E
O
B
D
T
oo
l
s
S
canner
Pr
e
vi
ous
V
e
hi
c
l
e
and Data
2. Position the battery pack (as shown)
with the arrows facing up. Tilt the top
of the battery in to align the tabs,
then down to install.
3. Install the battery pack cover, (in the
same manner as above) aligning
the tabs and screw.
4. Tighten the screw.
Note - Do not overtighten the screw.
A
5. Press the Power button.
7. Select a function (e.g. Scanner,
or Quick Lookups).
8. Navigate menus and functions
using the touch screen, or the control
buttons.
Y
- Accept selectionN - Cancel selection
Directional - Left/Right and Up/Down
Quick Lookups
OBD-II/EOBD
To ol s
Scanner
Previous Vehicle
and Data
Q
uick Lo
okups
O
BD-II
/
E
O
B
D
T
oo
l
s
S
canner
Pr
e
vi
ous
V
e
hi
c
l
e
and Data
1. Loosen the battery cover screw and
remove the battery cover.
Download the user manual from:
diagnostics.snapon.com/usermanuals
User Manual
a. From the Home screen, select
Tools > Settings > Configure Wi-Fi.
b. Select the Wi-Fi icon.
The icon will change to
indicating Wi-Fi is on.
c. Select a wireless network from
the list of available networks, then
select Connect.
***IMPORTANT***
Turn Wi-Fi on to use Quick Lookups.
6. To turn on Wi-Fi: