Features& Controls
Control Functions Figure 1. Controls
The information below briefly describes the function of individual controls. Starting, stopping, driving, and mowing
require the combined use of several controls applied in specific sequences. To learn what combination and sequence
of controls to use for various tasks see the OPERA TION section.
W Choke (Select lVlodels)
Close the choke for cold starting. Open the choke once
the engine starts. A warm engine may not require chok-
ing. Pull the choke control out to close the choke.
_I_IP__ Throttle Control
The throttle controls engine speed. Move the throttle for-
ward to increase engine speed and back to decrease
engine speed. Always operate at FULL throttle.
_1 Headlights
The light switch turns the tractor headlights on and off.
Front A×Je Oil LeveJ Plug
(4WD Models Only)
The front axle oil check plug/dipstick is used to check the
front axle oil level and to add oil to the axle, See FRONT
AXLE MAINTENANCE for oil level check and fill proce-
dures,
Transmission Oil LeveJ Check PJug
Transmission oil check plug/dipstick is used to check
transmission oil level and to add oil to the transmission.
See TRANSMISSION MAINTENANCE for oil level check
and fill procedures.
10
To Next Page
Loading...
