Electronic Dashboard
The electronic dashboard displays the total hours, trip hours,
digital clock, and cutting height (see Figure 3).
To*al Trip / Hours
%
\
\
\
J
A. Total Hours, Trip Hours, and Clock
B. Height-of-Cut
C. MODE and RESET Buttons
Figure 3
Display Total Hours, Trip Hours, and Clock
NOTE: Whenever you start up the unit. the Total Hours
are displayed. The Total Hours will automatically reset to 0
after 999.9.
1. Press MODE for less than 1 second to display the Trip
Hours.
2. Press RESET for greater than 3 seconds to reset the
Trip Hours to 0.
3. Press MODE for less than 1 second to display the
C_ock (see Set the Clock section).
4. Press MODE for less than 1 second to return to Total
Hours.
Set the Clock
1. Press MODE for greater than 3 seconds. The hours
will flash on the display.
2. Press RESET to adjust the hours.
3. Press MODE for less than 1 second to save the
setting. The minutes will flash on the display.
4. Press RESET to adjust the minutes.
5. Press MODE for less than 1 second to save the
setting.
14 www,snapper°com
To Next Page
Loading...
Need help?
General
