Snapper 2691021 - Troubleshooting the Mower

28
PROBLEM LOOK FOR REMEDY
Mower will not raise.
Lift linkage not properly
attached or damaged.
See authorized dealer.
Mower cut is uneven.
Mower not leveled properly. See authorized dealer.
Tractor tires not properly
inflated.
See Check Tire Pressure section.
Mower cut is rough
looking.
Engine speed too slow. Set to full throttle.
Ground speed too fast. Slow down.
Mower has other problem. See authorized dealer.
Engine stalls easily with
mower engaged.
Engine speed too slow. Set to full throttle.
Ground speed to fast. Slow down.
Dirty or clogged air filter. See Servicing Air Filter section.
Cutting height set too low. Cut tall grass at maximum cutting height during first pass.
Discharge chute jamming. Cut grass with discharge pointing toward previously cut area.
Engine not up to operating
temperature.
Run engine for several minutes to warm-up.
Starting mower in tall
grass.
Start the mower in a cleared area.
Excessive mower
vibration.
Mower has other problem. See authorized dealer.
Engine runs and tractor
drives, but mower will
not drive.
PTO not engaged. Engage the PTO.
Mower has other problem. See authorized dealer.
Troubleshooting the Mower
Not for
Reproduction