Snapper ERZT20441BVE2 - Specifications

33
Specifications
ENGINE:
20 HP* Briggs & Stratton
Make Briggs & Stratton
Model 20 hp ELS
Horsepower 20 @ 2700 rpm
Displacement 40.0 Cu. in (656 cc)
Electrical System 12 Volt, 9 amp. Alternator, Battery: 230 CCA
Oil Capacity 64 Oz. (1.9 L) w/ Filter
CHASSIS:
Fuel Tank Capacity: 3.0 Gallons (11.4 L)
Rear Wheels Tire Size: 18 x 8.50-8
Inflation Pressure: 15 psi (1,03 bar)
Front Wheels Tire Size: 11 x 4.00-5
Inflation Pressure: 25 psi (1,72 bar)
TRANSMISSIONS:
Hydro-Gear
ZA-DHBB-2D5A-2DCX (LH)
ZA-AHBB-2D5A-2DCX (RH)
Type EZT
Hydraulic Fluid Sealed Unit
Speeds Forward: 0-6.2 MPH (0-9.98 km/h)
@ Specified rpm Reverse: 0-3 MPH (0-4.83 km/h)
Continuous Torque 115 ft. lbs. (155 N.m.)
Output
Maximum Weight 340 lbs. (154 Kg) per Axle
on Axle
DIMENSIONS:
Overall Length 72” (182,9 cm)
Overall Width 55” (139,7 cm)
Height 38” (96,5 cm)
Weight (apx.)
Snapper 608 lbs. (276 kg)
Simplicity 624 lbs. (283 kg)
NOTE: Specifications are correct at time of printing and are subject to change without notice.
* Actual sustained equipment horsepower will likely be lower due to operating limitations and environmental factors.
CE COMPLIANCE SPECIFICATIONS:
Model ERZT20441BVE2 (Snapper) EJAV20441BVE2 (Simplicity)
RPM’s (Governed) 2700 2700
Kilowatts (kW) (@ Governed RPM’s) 11.29 11.29
Unit Mass (kg) 276 283
Sound Power (LWA) (dBA) 100 100
Sound Pressure (LPA) (dBA) 88 88
Vibration (Hand) (m/s2) 9.8 9.8
Vibration (Body) (m/s2) 0.7 0.7