Snapper ESPV21S - Page 5

HANDLES & CONTROLS
Footnotes:
TP 400-5150-1-WB-N
Manual No. 700620821" STEEL DECK EASY LINE EUROPEAN
5
Part No Descri
p
tionItem Qt
y
Note
1 7078247 1 HANDLE, Upper finish: flat black textured
2 7300130 1 PLATE, Control Panel finish: flat black textured
3 7100225 4 SCREW, #8-16 Recessed Pan Head (Torxplus)
4 7028488 1 GUIDE, Rope with 1/4-20 threads
5 7076978 1 NUT, 1/4-20 Hex Nyloc
6 7090391 4 WASHER, 5/16 Internal Tooth Lock
7 7035744 4 KNOB, 5/16-18 Wing (Black)
7 M720727 4 KNOB, 5/16-18 Wing (Black) Briggs part
8A 7100069 1 ASSY, Control Head Variable Speed (Incl. 8, 9, 10, 11, 12, 15 &
16)
8 1 CASE HALF, Bottom, Black not available individually
9 1 SPRING STEEL not available individually
10 1 CLUTCH LEVER, Silver not available individually
11 1 ASSEMBLY, Speed Lever/Friction Material not available individually;
includes 7100412, Friction Strip
12 1 CASE HALF, Top, Variable Speed- Black not available individually
13 7078248 1 BAIL, Brake finish: flat black textured
14 7100074 1 * CABLE, Zone Control
15 7100263 1 * CABLE, Clutch
16 7100264 1 * CABLE, Speed
17 7078246 1 HANDLE, Lower finish: flat black textured
18 7024649 2 WIRE TIE, 11 Inch Black Nylon
19 7091189 2 BOLT, 5/16-18 x 2” Curved Head Square Neck GR 2
20 7300103 2 BRACKET, Lower Handle finish: flat black textured
21 7091612 2 BOLT, 5/16-18 x 1-1/2” Round Head Square Neck, GR 5
22 7090799 7 BOLT, 5/16-18 x 5/8” Round Head Short Square Neck Carriage
23 7091601 4 NUT, 5/16-18 Hex Flange Lock
24 7072023 1 * CONTROL, Swivel Wheel Latch 56.5 (LH Outside)
25 7090505 1 SCREW, 1/4-20 x 2” Hex Head Cap, GR 5
26 7090372 3 NUT, 1/4-20 Hex Center Lock
27 7091135 2 PUSHNUT, 3/8”
28 7100632 2 FOAM GRIP, 7”
NOTE: * Snapper part numbers are stamped on cables.