9
Section 2 - OPERATING INSTRUCTIONS
2.3.5. CUTTING HEIGHT ADJUSTMENT
This machine has seven different cutting height
positions. IMPORTANT: When positioning the cutting
deck into a higher cutting position, pull up on the deck
lift handle only, it is not necessary to pull up on the
release lever at the same time. Use the release lever
when moving deck cutting height to a lower cutting
position.
1. Grasp both handles together to disengage
latch.
2. Raise or lower handles to desired height.
3. Release lower handle to engage latch. See
Figure 2.9.
FIGURE 2.9
WARNING
DO NOT park machine on slopes.
DECK LIFT
HANDLE
DECK LIFT HANDLE SHOWN
IN HIGHEST NOTCH.
RELEASE
LEVER
DETENT
PLATE
CONNECTING BAR OMITTED IN THIS
VIEW FOR CLARITY
To Next Page
Loading...
