Snapper NZM19480KWV - Page 49

HYDRO IDLER ASSEMBLY
Footnotes:
TP 400-5017-4-NZ-N
Manual No. 7006930MID MOUNT Z-RIDER
NZM SERIES 0 & 1
49
Part No Descri
p
tionItem Qt
y
Note
1 7014669 1 FITTING, 3/16” Straight Lube
2 7014409 2 BUSHING, 9/16” I.D.
3 7035816 1 PIN, Idler Arm (3/8-24 Thread)
4 7018574 1 PULLEY, Flat Idler 4.12” (Backside Idler)
5 7059094 1 WELDMENT, Idler Arm
6 7073992 1 SPRING, Extension
7 7075109 1 BELT, Hydro Drive (HA Section, 47.5 Effective Length) used on Series 0
-- 7075109 1 BELT, Hydro Drive (5L Section, 47.5 Effective Length) Was 75626 (used on Series 1)
8 7091585 2 NUT, 3/8-16 Hex Center Lock
9 7091497 2 SCREW, 3/8-16 x 1-1/2 Hex Head Cap GR5
10 7091518 1 NUT, 3/8-24 Hex Nyloc
11 7091598 1 PIN, 1/8 x 3/4” Cotter
12 7091804 2 WASHER, 9/16” Flat
13 7091619 1 NUT, 3/8-16 Hex Flange Lock
14 7075078 1 SWIVEL, Adjustable
15 7028728 1 ADJUSTER, Chain (5/16-18 Thread)
16 7028620 1 SPACER, .340 I.D. x .63 O.D. x .310 Thick
17 7091511 1 NUT, 5/16-18 Hex, GR5 or B
18 7091503 1 HAIR PIN, 3/32 x 1-1/2”
19 7090122 3 WASHER, 3/8” Flat SAE
20 7091298 1 NUT, 5/16-18 Hex Nyloc
21 7091553 1 SCREW, 3/8-16 x 1-3/4” Hex Head Cap GR5