Snapper RT5 series - TINE ROTATION SELECTION; CHANGE TINE ROTATION: REVERSE TO FORWARD; CHANGE TINE ROTATION: FORWARD TO REVERSE

TINE ROTATION SELECTION
FIG. 1. 8 ■ TINE BELT DRIVE-PULLEY
CHANGE TINE ROTATION with engine off as
follows: Remove the wing-nut and washer on the
front stud of the belt cover, pull the cover outward
over this stud then swing the cover rearward and out
of the way over the belt pulley. With the clutch con¬
trol released, there is sufficient slack to slip the belt
off the pulley for changing the arrangement as
shown in figure 8.
TO CHANGE FROM REVERSE TO FORWARD: TAKE
BELT OFF BOTTOM OF BIG PULLEY. PULL
TOWARD YOU AND HOLD IN LEFT HAND. REMOVE
BELT FROM TOP AND PULL DOWN. PLACE BELT
(HELD BY LEFT HAND) UNDER LITTLE PULLEY
AND OVER BIG PLULLEY.
TO FORWARD (A)
FIG. 1.9- REVERSE TO FORWARD (A)
TO FORWARD (B)
FIG. 1.9- REVERSE TO FORWARD (B)
TO REVERSE •
FIG. 1. 10 ■ FORWARD TO REVERSE
When in forward mode for cultivating between rows,
the tines do not have to be switched from side to
side, however, the Tiller will thus break previously
tilled soil to a depth of on ly 1 or 2 inches. To dig un¬
filled soil or to till deeper for seed bed preparation,
switch the tines from right to left side.
TO CHANGE FROM FORWARD TO REVERSE: TAKE
BELT OFF TOP OF BIG PULLEY, PULL TOWARD
YOU AND HOLD. LIFT BELT FROM BOTTOM AND
PUT IN TOP OF PULLEY.
• MAKE SURE BELT IS RUNNING TRUE UNDER LIT¬
TLE PULLEY, AROUND BIG PULLEY, AND ABOVE
GUIDE PIN.
• SWING BELT COVER FORWARD & INSTALL
WINGNUT.
1-3