Snapper SGV13320KW - Page 29

GVTP SM32-R0303.1
Snapper 32” Cut Mower
R0303.1
SHEET 4 - HANDLE GROUP
REF # PART # QTY DESCRIPTION
1 3023511 1 Handle assembly
--- 3032136 1 Mower dash overlay decal
2 3031283 2 Handle grip - 1"dia x 4-1/2"
3 3031122 4 1/2-13 x 1-1/4" hex bolt
4 3032130 4 1/2-13 serrated flange nut
5 3023259 2 Brake handle
6 3031379 2 Handle grip - 1/4" x 3/4" x 4"
7 3031710 2 1/4-20 x 2" hex bolt
8 3031098 2 1/4-20 lock nut
9 3023131 2 Upper brake rod
10 3023184 1 Brake lock - left
--- 3023130 1 Brake lock - right
11 3031292 2 1/4-20 x 1-1/2" hex bolt
12 3031579 2 1/4" spring washer
13 3031098 2 1/4-20 lock nut
14 3031890 2 5/16" fender washer
15 3031381 2 #1 bridge pin
16 3023512 1 Safety switch rod
17 3031693 2 3/8" id flange bushing
18 3023167 1 Safety handle - left
--- 3023166 1 Safety handle - right
--- 3031439 2 5/16-18 x 1/4” socket set screw
19 3031480 1 Handle safety switch
20 3031100 2 3/16 pop rivet
21 3031585 1 Safety switch spring
22 3035020 1 Throttle control
22a 3032140 1 Snap bushing - .500 id
22b 3035021
1 Auxiliary choke cable (not shown)
--- 3079253 1 Decal – ‘Pull for Choke’ (applied to mower dash overlay)
23 3031100 2 Pop rivet (attaches throttle to handle dash)
--- 3031007 2 Throttle cable clip (fastens cable to handlebar)
24 3031584 1 Throttle T-handle
25 3032011 1 Off switch
--- 3031808 1 3” jumper wire – 1/4” female to 1/4” ring – Off switch ground
26 3031806 1 5/8” star washer
27 3031581 1 5/8-18 jam nut
28 3039108 1 Key set (set of 2)
29 3032137 1 PTO switch
30 3027504 1 Safety instruction decal bracket
--- 3075601 1 Safety instruction decal
31 3031031 2 5/16-18 x 3/4” hex bolt
32 3031986 2 5/16-18 small serrated flange nut
33 3032148 1 Wiring harness