English (original instructions)
EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
String will not advance when
using the bump-feed head.
String is welded to itself. Lubricate with silicone spray.
Not enough string on
spool.
Install more string. Refer to
string replacement earlier in this
manual.
String is worn too short. Pull string while pressing line
release button.
String is tangled on
spool.
Remove string from spool
and rewind. Refer to string
replacement earlier in this
manual.
Grass wraps around shaft
housing and string head.
Cutting tall grass at
ground level.
Cut tall grass from the top down
to prevent wrapping.
Motor fails to start when
switch trigger is depressed.
Battery is not secure. To secure the battery pack,
make sure the latch on bottom
of the battery pack snaps into
place.
Battery is not charged. Charge the battery pack
according to the instructions
included with your model.
Shaft not connected
completely.
Make sure lower shaft is fully
seated in shaft coupler on upper
shaft and secure shaft coupler.
To Next Page
Loading...
