Need help?Do you have a question about the Snell E.5mk2 and is the answer not in the manual?
General| Weight | 75 lbs |
|---|---|
| Sensitivity | 90 dB |
| Impedance | 4 ohms |
| Dimensions | 12 x 12 inches |
| Woofer | 10 inch |
| Tweeter | 1 inch dome |
Details the floorstanding system's design, driver complement, and frequency response.
Describes the high-performance monitor for cabinet or stand use, highlighting its two-way design.
Explains the full-range center channel, its 2.5-way design, and suitability for surround sound.
Three-layer sandwich design isolating the baffle for reduced resonances and distortion, especially in midrange.
Elliptical radius on baffle edge reduces re-radiation for cleaner, smoother off-axis response.
Custom-perforated metal grille with no frame to avoid degrading reflections. Rubber mounts isolate grille posts.
Networks tuned to within ±0.5dB of Master Reference for predictable performance.
Cabinets are hand-assembled, hand-sanded multiple times for exceptional workmanship and smooth sides.
Uses book-matched, premium veneers chosen for grain consistency and aesthetics. Veneer sequenced for matching.
Switch 'normalizes' speaker for cabinet or near-object placement, assuring predictable performance.
Die-cast aluminum heat sink for stable performance. Terminal plate has five-way binding posts.
Adds high-end fill for broader stereo image. Has an on/off switch for placement against a back wall.
Guidance for freestanding vs. boundary placement, including carpet spike usage for the E.5mk2 Tower.
Guidance for freestanding vs. cabinet placement, including horizontal/vertical orientation.
Instructions for TV top vs. cabinet placement, and positioning relative to other speakers.
Instructions for setting the placement switch to NORMAL or BOUNDARY based on speaker location.
How to adjust the treble control to contour the speaker's brightness based on room acoustics.
Guidance on turning the rear-firing tweeter ON/OFF for optimal ambiance and soundstage.
Instructions on attaching felt bumpers to the CR.5mk2 to protect surfaces.
Advice on stand height and its impact on bass response due to proximity to boundaries.
Guidance on adjusting speaker position relative to walls and corners to control bass response.
Tips on speaker distance and listener position to create a wide and continuous stereo image.
How to adjust speaker angle (toe-in) to achieve a more direct-sounding stereo effect.
Instructions for cleaning black or white painted finishes using soft, damp cloths and mild detergent.
Guidance on cleaning oiled wood veneers and applying wood oil if they dry out.
How to remove and clean speaker grilles with a damp cloth to remove dust.
Recommendations for speaker cable gauge (16-gauge up to 25ft, 12-gauge for longer runs).
Instructions for connecting bare speaker wire by inserting it into holes and tightening.
Information on using banana plugs, spade lugs, or pins with binding posts.
Details basic connections, bi-wiring, and bi-amplifying for the E.5mk2 and K.5mk2 models.
Instructions for using identical amplifiers for each speaker's channels, including wiring details.
Guidance on setting receiver/processor for main/center channels with or without a powered subwoofer.
Specific instructions for connecting the CR.5mk2 center channel to a surround processor.
Covers defects in materials/workmanship for five years. Excludes damage from abuse, misuse, or unauthorized repairs.
User must provide safe transport, proof of purchase, and ensure serial number is intact.
Provides instructions for contacting dealers or Snell Acoustics for service and return procedures.
To Next Page