How to configure snom 700/ D7XX Series for 3CX
This guide applies to v15.5 only.
On this topic
Supported Models: snom 700/D7XX series
snom 700 series
snom D7XX series
End of Life
Step 1: Upgrade to the Required firmware
Step 2: Factory Reset the IP Phone
Step 3: Provision the phone
Local LAN or SBC: Provision via Plug’n’Play
Remote phones: Provision via RPS server
Step 4: Extended Phone Configuration
Known Limitations
Supported Models: snom 700/D7XX series
snom 700 series
● snom 715
snom D7XX series
● snom D712
● snom D715
● snom D725
● snom D745