V: 12/19/2024 - 1 ©2024 Snom Technology GmbH 13/19
Short User Manual
(4) Active calls
One call on hold
Press
Hold
or press the
function key
underneath the
following
symbol
Hold
to put the ongoing call on hold. Held calls are
indicated as follows:
By the text on the display.
By the slowly blinking line key.
By the slowly blinking call indication LED.
By the double beep when you put a call on hold.
You can now:
transfer the held call blindly or with prior
announcement.
receive and make calls and put other calls on hold.
Pick up the held call by pressing its line key or press
again
Hold
or press the
function key
underneath the
following
symbol
Retrieve
If the other party hangs up while on hold, the call is
terminated on your phone as well and the LED
indicators are turned off.
Holding multiple calls
If you are in a call with one party and have one or
more calls on hold or if there is more than one call on
hold, the following symbols are shown in the function
key line according to the use case.
Back to active
call
Previous held
call
Next held call
You can now:
switch back and forth between the active call and
any call on hold. Up to 2 simultaneous calls are
possible, if supported by the VoIP telephony
system.
When the connected call is on-screen, you can
transfer it to a third party or terminate it.
When a held call is on-screen, press
Ok
to connect to it and put the
currently connected call on hold.
To Next Page
Loading...
