Page 3 - 9UL25/UL32/UL40
3. Slide #4 mast out of #3 mast. As mast is removed, the bottom four mast bearings will fall out;
note their orientation for re-assembly.
4. Disconnect the chain from the top of the #2 mast.
5. Remove the cylinder by following instructions provided under the section named “CYLINDER
ASSEMBLY”.
#3 MAST
1. Remove the sequence strap retainer on the top of #1 mast.
2. Remove the Allen head screws holding the top mast bearings between the #2 and #3 mast. Re-
move the top mast bearings.
3. Slide #3 mast out of #2 mast. As mast is removed, the bottom four mast bearings will fall out. Its
important to note their orientation for re-assembly.
#2 MAST
1. Remove the Allen head screws holding the top mast bearings between the #1 and #2 mast. Re-
move the top mast bearings.
2. Slide the #2 mast out of the #1 mast. As mast is removed, the bottom four mast bearings will fall
out. Its important to note their orientation for re-assembly.
SERVICE AND REPAIR
To Next Page
Loading...
