SNOWJOE SJ623E - Operation; Securing the Extension Cord

8
8
4. Remove the hitch pin from the lower chute crank (Fig. 9).
5. Slide the upper chute crank through the rubber ring
located on the middle frame (Fig. 10).
6. Slide the upper chute crank into the lower chute crank
(Fig. 11).
7. Align the screw holes and secure with the hitch pin
(Fig. 12).
Operation
NOTE:Before using this machine, make sure that the power
source you will use complies with the specications detailed
in this manual. Before inserting the plug into the socket, verify
that the snow thrower’s roll shaft and rubber plates are rmly
secured with screws, and that the rubber plates are facing the
correct direction. Perform a test run to ensure that the rotor
turns freely.
Securing the Extension Cord
1. For safe and ecient use of your snow thrower, use only
a UL-rated extension cord recommended for outdoor use.
Refer to the Extension Cord Chart on page 3.
2. Push the loop of the extension cord through the slot from
the opposite side of the restraint hook. Position the loop
over the hook and pull the cable back through the slot
(Fig. 13).
3. Insert the female end of the extension cord into the
appliance's polarized male plug (Fig. 14).
Fig. 9
Lower chute
crank
HitchPin
Fig. 10
Rubber ring
Upper chute crank
Fig. 11
Upper chute
crank
Lower chute
crank
Fig. 12
HitchPin
Fig. 13